Product Info and Resources

These instructions are intended for certified professional electricians.

Griplock Power Over Suspension System.

This is the full video that shows how to install your linear pendant using the Griplock power over suspension system.

This applies to S-Light, SiteLines, Beam, Kelp Pendant, Luma Pendant & Petala

Separate install stages.

This set allow you to see the stage of the install that is most relevant to you.

Coaxial Power Over Suspension Install Video

Applies to Two50 Pendants & Linea up/down

Single box suspension install:

Attach low voltage feed to terminals on the suspension cable

Attach low voltage feed to terminals on the suspension cable

Thred the cable through the suspension plate so that the stops on the cable sit in this hole.

Thred the cable through the suspension plate so that the stops on the cable sit in this hole.

Attach suspension plate to junction box using screws and black rubber spacers provided.

Attach suspension plate to junction box using screws and black rubber spacers provided.

Snug the plate up to the ceiling so that the spacers are keeping the plate off the ceiling.

Snug the plate up to the ceiling so that the spacers are keeping the plate off the ceiling.

Feed cables through the holes in the cover and press over threaded ends.

Feed cables through the holes in the cover and press over threaded ends.

Feed cable through covers and finger tighten snugly.

Feed cable through covers and finger tighten snugly.